Three Signs that Something Is Wrong with Your Rolex

Rolex watches are very well made and designed to last for generations. Even though these watches are designed to look great and stand the test of time, they will need to be repaired from time to time. If you notice that your Rolex is not telling time accurately, you need to get it serviced. Use the following guide to learn more about issues that may need to get addressed to get your Rolex working properly.

The Watch Is Running Slow

Rolex watches have fully automatic movement, which means they have to be wound using the motion of your arm or a stem. If you have a Rolex that has a battery in it, you do not have an authentic Rolex watch. There is lubrication inside of the casing that keeps the gears working properly. If your watch has difficulty keeping the accurate time, there is a good chance the lubrication has started to dry up and create gunk between the gears. When this happens, a watch repair shop needs to clean the watch and then lube it properly.

There Is a Fog Under the Crystal

Over time, the seal around the edge of the watch casing may become broken down and allow your sweat to get into the watch. When this happens, condensation can develop under the crystal of the watch, causing a fog to develop. If you notice there is a fog in the watch, take it to a repair shop right away. The gears in the watch will start to rust from the moisture and cause significant damage to your watch.

A professional can ensure that the watch is dried out properly and the seal is replaced. Opening the watch casing and allowing the watch to dry out at home is not a good idea because special tools need to be used to ensure that the moisture does not cause the parts to rust.

The Arms Have Stopped Moving

The arms of a Rolex watch should never stop moving. If you notice that the arms have stopped or have slowed down dramatically, try putting your watch on and walking around for an hour or so and check it again. If you haven't worn your watch for a few days or weeks, it will need to be wound and wearing it may be the only way to do that.

As soon as the watch is wound, it should start working properly. If it does not start working properly after wearing it for an hour, take it to the watch repair shop because there may be a broken gear or axle that needs to be replaced. This is a simple fix that can often be done within a matter of minutes.

Rolex watches are usually quite expensive, so you need to make sure that you take care of them properly. You should have the watch serviced every few years by expert resources like Arc Watch Works And Engraving to ensure that all of the parts are working properly and that it is well lubricated. Taking care of your watch now could save you from a lot of costly repairs later on down the road.